300 – 400 SF/Gal over profiled concrete

300 SF/Gal Standard coverage rate

50 SF/Gal

150 SQFT per 3gal Kit.

100 SF/Gal

⎯⎯⎯⎯

NOTE: This product can be used in different applications, but if you need the Manufacturer warranty for MVB15 it cannot be: Applied any more than 100 SF/Gal, Pigmented, Accelerated, Broadcast into and surface MUST be shot blasted.

150 / 200 SF/Gal

⎯⎯⎯⎯

This particular epoxy has an extended work time of up to 45 min, very strong UV Resistance and is ideal for a top coat sealer clear or pigmented.

300 SF/Gal

⎯⎯⎯⎯

Generally, however when going over freshly profiled concrete your initial coat of sealer may only get as much as 150 – 200 SF/ Gal depending on the porosity of the concrete surface.

175 – 200 SF/Gal over profiled concrete

200 – 250 SF/Gal over smooth surfaces (generally as a 2nd coat of epoxy)

100 – 175 SF/Gal over broadcast surfaces such as Sand, Quarts, and Flake

200 SF/Gal – Standard Coverage rate over flat surfaces… May leave you w/Orange peel

150 SF/Gal – This is for a very nice glassy – flat type finish.

100 – 175 SF/Gal – Over broadcast surfaces – Flake, Quartz, Sand

200 – 300 SF/Gal over flat surfaces

100 – 175 SF/Gal over broadcast surfaces – Flake, Quartz, Sand

⎯⎯⎯⎯

NOTE: This is a very versatile sealer Highly Chemical and abrasion resistant, UV Stable and ideal as a top coat sealer for almost any type of system available

500 – 600 SF/Gal – This particular sealer actually MUST be rolled out at the specified coverage rate. Going less can cause white spots, small clumps, and unevenness.

⎯⎯⎯⎯

NOTE: This sealer is designed to ONLY be applied to smooth flat surfaces, i.e: over epoxy, concrete that has been primed w/either a Waterbase or 100% Solids Epoxy or stained with WB Acrylic Stain… NOT Acid or Acetone based stain.

200 – 225 SF/Gal

Perks to this Epoxy are:
- Highest adhesion rating to concrete
- “350”, Lifetime Adhesion Warranty
- Holds back up to 9 lbs. of Moisture Vapor Transmission.

⎯⎯⎯⎯

NOTE: This epoxy is specifically designed to be a PRIMER COAT ONLY! You must broadcast to refusal or top coat this product w/another coat of either “PIGMENTED” Epoxy or Sealer or risk serious ambering.

35 SF/Kit at 3/16” Thickness – This is industry standard thickness for this product.

48 – 50 SF/Kit at 1/8” Thickness – This thickness is not recommended because the product dose not easily gage rake out when it is this thin or aerate out very well.

24 – 26 SF/Kit at ¼” Thickness

⎯⎯⎯⎯

NOTE: SQFT Coverages may very due to unevenness and bird bathing on the surface of the slab causing you to use more product.